|
SHOWER BASES
|
Florestone Terrazzo
Model 500 Barrier-Free
Shower Bases
Architect’s
Specifications
Furnish and install wheelchair accessible Terrazzo Shower Base Model 500 as manufactured by Florestone. Flanges on three sides, cast integral, shall be of galvanized-bonderized steel and shall extend not less than 1" above the shoulders. Shoulders on three sides shall be not less than 2½" inside. Threshold shall be not more than ½" above base floor to allow for barrier free entrance with an integral ramp. Drain body shall be brass, cast integral, and shall provide for a non-caulked connection not less than one inch deep to a 2" pipe. Removable type stainless steel strainer plate shall be supplied. Base shall be manufactured of tan and white marble chips cast in white Portland cement to produce a compressive strength of not less than 3,000 PSI, seven days after casting. Terrazzo surface shall be ground, polished, and the entire unit sealed to resist stains and moisture. Bases reinforced with 16-gauge wire.
Options
Offset drain.
Additional flanges. (Drawings required)
|
|
Model 500
Barrier free Terrazzo Shower Bases with built-in stainless steel ramp.
Click for Large View
|
Note: Terrazzo is not designed to be used with anything
that is over 130 degrees Fahrenheit.
|
| A |
B |
C |
D |
E |
HT |
WT |
|
| 36" |
36" |
18" |
18" |
12" |
7" |
315 |
| 40" |
40" |
20" |
20" |
12" |
7" |
370 |
|
| 42" |
48" |
21" |
21" |
12" |
7" |
510 |
| 48" |
48" |
24" |
24" |
18" |
7" |
550 |
|
| Note: Exterior floor drain for water run-off recommended. |
|
Dimensions subject to
change without notice
|
Contact Florestone Products to
verify product specifications.
|
|
Standards:
|
|
I.A.P.M.O. |
International Association of Plumbing and Mechanical Officials File No. 0687.
|
|
|
|
CAD Drawings are compressed in zip format (.zip)
|
Model PDF