|
ACCESSIBLE
|
Florestone
Model 500 Barrier-Free
Terrazzo Bases
Architect's
Specifications
Furnish and install wheelchair accessible Terrazzo Shower Base Model 500 as manufactured by Florestone. Flanges on three sides, cast integral, shall be of galvanized-bonderized steel and shall extend not less than 1" above the shoulders. Shoulders on three sides shall be not less than 2½" inside. Model 500 to have integral ramp. Drain body shall be brass, cast integral, and shall provide for a non-caulked connection not less than one inch deep to a 2" pipe. Removable type stainless steel strainer plate shall be supplied. Base shall be manufactured of tan and white marble chips cast in white Portland cement to produce a compressive strength of not less than 3,000 PSI, seven days after casting. Terrazzo surface shall be ground, polished, and the entire unit sealed to resist stains and moisture. Bases reinforced with 16-gauge wire.
Options
Offset drain
Additional flanges
(Drawings required)
Dimensions may vary ± ¼ inch. Please check unit before installation.
|
For barrier-free installation, contractor shall provide recess for curb in sub floor.
|
|
Standards:
|
I.A.P.M.O. Listed File 0687 |
|
ANSI-Z-124.2 |
|
|
Note: Terrazzo is not designed to be used with anything
that is over 130 degrees Fahrenheit. |
Dimensions subject to
change without notice
|
Contact Florestone Products to
verify product specifications.
|
|
|
|
CAD Drawings are compressed in zip format (.zip)
|
Installation PDF